OP471 Datasheet, PDF (3/16 Pages) Analog Devices – High Speed, Low Noise Quad Operational Amplifier

OP471
ELECTRICAL CHARACTERISTICS (Vs = ±15 V, –25؇C £ TA £ 85؇C for OP471E/F, –40؇C £ TA £ 85؇ for OP471G,
unless otherwise noted.)
Parameter
Input Offset Voltage
Average Input
Offset Voltage Drift
Input Offset Current
Input Bias Current
Large-Signal
Voltage Gain
Input Voltage Range*
Output Voltage Swing
Common-Mode
Rejection
Power Supply
Rejection Ratio
Supply Current
(All Amplifiers)
Symbol Conditions
V_OS
TCV_OS
OP471E
Min Typ Max
0.3 1.1
14
OP471F
Min Typ Max
0.6 2.0
27
OP471G
Min Typ Max
1.2 2.5
4
los
I_B
Avo
IVR
V_O
CMR
V_CM = 0 V
V_CM = 0 V
V_O = ± 10 V
R_L = 10 kW
R_L = 2 kW
R_L ≥ 2 kW
V_CM = ± 11 V
5 20
13 50
375 600
250 400
± 11 ± 12
± 12 ± 13
100 115
8 40
25 70
200 400
125 200
± 11 ± 12
± 12 ± 13
90 110
20 50
40 75
200 400
125 200
± 11 ± 12
± 12 ± 13
90 110
PSRR V_S = ± 4.5 V to ± 18 V
3.2 10
18 31.6
18 31.6
I_SY
No Load
9.3 11
9.3 11
9.3 11
Unit
mV
mV/∞C
nA
nA
V/mV
V
V
dB
mV/V
mA
*Guaranteed by CMR test.
ABSOLUTE MAXIMUM RATINGS¹
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 18 V
Differential Input Voltage² . . . . . . . . . . . . . . . . . . . . . . ± 1.0 V
Differential Input Current² . . . . . . . . . . . . . . . . . . . . ± 25 mW
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . Supply Voltage
Output Short-Circuit Duration . . . . . . . . . . . . . . . Continuous
Storage Temperature Range
P, Y-Package . . . . . . . . . . . . . . . . . . . . . . –65∞C to +150∞C
Lead Temperature Range (Soldering, 60 sec) . . . . . . . . 300∞C
Junction Temperature (T_i) . . . . . . . . . . . . . –65∞C to +150∞C
Operating Temperature Range
OP471E, OP471F . . . . . . . . . . . . . . . . . . . –25∞C to +85∞C
OP471G . . . . . . . . . . . . . . . . . . . . . . . . . . . –40∞C to +85∞C
NOTES
1_{Absolute Maximum Ratings apply to packaged parts, unless otherwise noted.}
2_{The OP471’s inputs are protected by back-to-back diodes. Current limiting}
resistors are not used in order to achieve low noise performance. If differential
voltage exceeds ± 1.0 V, the input current should be limited to ± 25 mA.
Package Type
␪_JA*
14-Lead Hermetic DIP(Y)
94
14-Lead Plastic DIP(P)
76
16-Lead SOIC (S)
88
␪_JC
Unit
10
∞C/W
33
∞C/W
23
∞C/W
*␪_JA is specified for worst-case mounting conditions, i.e., ␪_JA is specified for device
in socket for TO, CERDIP, PDIP packages; ␪_JA is specified for device soldered to
printed circuit board for SO packages.
ORDERING GUIDE
T_A = 25∞C
V_OS MAX
(mV)
800
1,500
1,800
1,800
Package Options
14-Lead CERDIP Plastic
OP471EY
OP471FY*
OP471GP
OP471GS
Operating
Temperature
Range
IND
IND
XIND
XIND
*Not for new design. Obsolete April 2002.
For military processed devices, please refer to the standard
microcircuit drawing (SMD) available at
www.dscc.dla.mil/programs/milspec/default.asp
5962-88565022A - OP471ARCMDA
5962-88565023A - OP471ATCMDA
5962-8856502CA - OP471AYMDA
CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection. Although
the OP471 features proprietary ESD protection circuitry, permanent damage may occur on
devices subjected to high-energy electrostatic discharges. Therefore, proper ESD precautions
are recommended to avoid performance degradation or loss of functionality.
REV. A
–3–
WARNING!
ESD SENSITIVE DEVICE