EVAL-ADG788EBZ_15 Datasheet, PDF (3/8 Pages) Analog Devices – Evaluation Board for ADG788 Triple SPDT Switch in Chip Scale Package

EVALUATION BOARD HARDWARE
The ADG788 evaluation board kit contains the following:
• A fully fitted printed circuit board
• A CD containing the ADG788 product data sheet and the
evaluation board data sheet
The evaluation board allows the user to connect the signals that
require switching to the ADG788 switch and control its operation
by using the on-board links or by applying the correct control
signals to the appropriate connectors. The signals present at the
pins of the ADG788 can be monitored using the test point
provided on the board.
The following sections describe the function of all connectors
and links.
EVAL-ADG788EBZ
POWER SUPPLY
To operate the ADG788 evaluation board, the user must provide
an external power supply connected to Power Block P1. The
supply voltage range is 1.8 V to 5.5 V for single-supply operation
and ±2.5 V for dual-supply operation. The user can select single-
supply operation or dual-supply operation using Link J23, as shown
in Table 1.
Table 1. Link J23 Configuration
Position Operation Mode
A
Single-supply operation
B
Dual-supply operation (default configuration)
SWITCH CONTROL
The four input pins, IN1, IN2, IN3, and IN4, control the opera-
tion of the ADG788. Link J8, Link J9, Link J12, and Link J13
control the logic levels applied to these pins and allow the user
to drive these pins with external signals applied to Connector J5
and Connector J11 (the signals have 50 Ω on-board termination
resistors to GND). Table 2 describes the configuration achieved
for each position of these links.
Table 2. Link J8, Link J9, Link J12, and Link J13 Settings
Link Position
ADG788 Switch Status
J8 Removed
S2A to D2 = off, S2B to D2 = on
A
S2A to D2 = on, S2B to D2 = off
B (default configuration) Controlled via signal applied to Connector J5_TOP
J9 Removed
S3A to D3 = off, S3B to D3 = on
A
S3A to D3 = on, S3B to D3 = off
B (default configuration) Controlled via signal applied to Connector J5_BOTTOM
J12 Removed
A (default configuration)
S1A to D1 = off, S1B to D1 = on
Controlled via signal applied to Connector J11_BOTTOM
B
J13 Removed
A (default configuration)
S1A to D1 = on, S1B to D1 = off
S4A to D4 = off, S4B to D4 = on
Controlled via signal applied to Connector J11_TOP
B
S4A to D4 = on, S4B to D4 = off
High: S2A to D2 = on, S2B to D2 = off
Low: S2A to D2 = off, S2B to D2 = on
High: S3A to D3 = on, S3B to D3 = off
Low: S3A to D3 = off, S3B to D3 = on
High: S1A to D1 = on, S1B to D1 = off
Low: S1A to D1 = off, S1B to D1 = on
High: S4A to D4 = on, S4B to D4 = off
Low: S4A to D4 = off, S4B to D4 = on
Rev. 0 | Page 3 of 8