5962R8856501VCA Datasheet, PDF (3/5 Pages) Analog Devices – Very low noise, quad, operational amplifier

OP470
Very low noise, quad, operational amplifier
Table I - Electrical Characteristics (continued)
Parameter
Symbol
Conditions
1/
Sub- Limit
groups Min
Output Voltage Swing 4/ V_OP
Supply Current 2/
I_SY
R_L = 2Kohm
4, 5, 6, ±12
No Load
1, 2, 3
M, D, L, R 1
Input Voltage Range 4/ IVR
1, 2, 3 ±11
Slew Rate 4/
SR A_VLC = +21, R_L = 10kΩ 7
1.4
Common Mode Rejection 4/ CMR
V_CM = IVR 3/
1
110
2, 3 100
Power Supply Rejection
Ratio 4/
PSRR
V_S = ±4.5V to ±18V
1
2, 3
Limit
Max
11
11
1.8
5.6
Units
V
mA
V
V/μV
dB
μV/V
Table I Notes:
1/ V_S = ±15V, R_S = 50Ω, unless otherwise specified.
2/ I_SY limit equals the total of all four amplifiers.
3/ IVR is defined as the V_CM range used for the CMR test.
4/ Not tested Post Irradiation.
4.1 Electrical Test Requirements:
Table II
Test Requirements
Interim Electrical Parameters
Final Electrical Parameters
Group A Test Requirements
Subgroups (in accordance with
MIL-PRF-38535, Table III)
1
1, 2, 3, 4, 5, 6 1/ 2/
1, 2, 3, 4, 5, 6, 7
Group C end-point electrical parameters 1, 2, 3 2/
Group D end-point electrical parameters 1
Group E end-point electrical parameters 1
1/ PDA applies to Subgroup 1 only. Delta's excluded from PDA.
2/ See Table III for delta parameters. See table I for conditions.
4.2 Life Test and Burn-In Delta Limits:
TEST
TITLE
Table III
BURN-IN LIFETEST
ENDPOINT ENDPOINT
DELTA
LIMIT
UNITS
V_IO
±0.4
±0.5
±0.1
mV
I_IB
±25
±30
±5
nA
I_IO
±10
±15
±5
nA
ASD0013059 Rev. B
25-Sep-07
Page 3 of 5