AD1888 Datasheet, PDF (25/32 Pages) Analog Devices – AC 97 SoundMAX Codec

AD1888
Serial Configuration Register (Index 74h)
Reg
No. Name D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0 Default
74h Serial SLOT16 REGM2 REGM1 REGM0 REGM3 DRF X CHEN X LBKS1 LBKS0 INTS X SPAL SPDZ SPLNK 1001h
Configuration
All registers not shown and bits containing an X are assumed to be reserved.
Note that this register is not reset when Register 00h (Reset Register) is written to (soft reset).
SPLNK
SPDZ
SPAL
INTS
LBKS[1:0]
CHEN
DRF
REGM3
REGM0
REGM1
REGM2
SLOT16
SPDIF Link. This bit enables the SPDIF to link with the front DACs for data requesting.
0 = SPDIF and DAC are not linked.
1 = SPDIF and DAC are linked and receive the same data requests (reset default).
SPDIF DACZ.
0 = Repeat last sample out of the SPDIF stream if FIFO underruns (reset default).
1 = Forces midscale sample out the SPDIF stream if FIFO underruns.
SPDIF ADC Loop-Around.
0 = SPDIF transmitter is connected to the AC-Link stream (reset default).
1= SPDIF transmitter is connected to the digital ADC stream, not the AC-Link.
Interrupt Mode Select. This bit selects the JS interrupt implementation path.
0 = Bit 0 SLOT 12 (modem interrupt) (reset default).
1 = Slot 6 Valid Bit (MIC ADC interrupt).
Loop-Back Selection. These bits select the internal digital loop-back path when LPBK bit is active (see Register 20h)
00 = Loop-back through the front DACs (reset default).
01 = Loop-back through the surround DACs.
10 = Reserved
11 = Loop-back through the center and LFE DACs (center DAC loops back from the ADC left channel, the LFE
DAC from the ADC right channel).
Chain Enable. This bit enables chaining of a slave codec SDATA_IN stream into the ID0 pin (Pin 45).
0 = Disable chaining (reset default).
1 = Enable chaining into ID0 pin.
DAC Request Force. This allows the AD1888 to synchronize DAC requests with the AD1981A/B.
0 = Normal DAC requesting sequence (reset default).
1 = Synchronize to AD1981A/B DAC requests.
Slave 3 Codec Register Mask
Master Codec Register Mask
Slave 1 Codec Register Mask
Slave 2 Codec Register Mask
Enable 16-Bit Slot Mode. SLOT16 makes all ac-link slots 16 bits in length, formatted into 16 slots. This is a
preferred mode for DSP serial port interfacing.
REV. 0
–25–