English
Language : 

AD9561_15 Datasheet, PDF (2/8 Pages) Analog Devices – Pulse Width Modulator
ANALOG DEVICES FAX-aN-DEMAND HOTLINE - Page
AD9561-SPECIFICATIONS = (+Vs +5 V;Rm =715fl, CLOCK=20MHzunlessotherwisenoted)
Parameter
RESOLUTION
Temp
AD956lJR
Mill
Typ
Max
8
Units
Bits
ACCURACY (@ 20 MHz)
Differential Nonlinearity
Integral linearityl
OddJEven Pulse Mismatch2
+25°C
+25°C
+25°C
:to.5
:t2
LSB
:t1.5
:t4
LSB
:to.75
LSB
DIGITAL INPUTS
Logic "1" Voltage
Filll
2.0
V
Logic "0" Voltage
Filll
0.8
V
Input Current
Filll
:tl
fJA
Input Capacitance
+25°C
5
pF
OBSOLETE Data Setup Time
Data Hold Time
Minimum Clock Pillse Width (HIGH)
DYNAMIC PERFORMANCE
Maximum Trigger Rate
Minimum Propagation Delay (tpD)3
Minimum Propagation Delay TC
Output Pillse Width @ Code 254
Output Pillse Width @ Code 255
Output Rise Times, 6
Output Fall Times, 6
RETRACE Propagation Delay
PWM OUTPUT
Logic "1" VoltageS,6
Logic "0" VoltageS,6
CAL OUT
Filll
Filll
Filll
Filll
+25°C
Filll
Filll
Filll
Filll
Filll
Filll
Filll
Filll
2.0
0.3
2.0
0.3
6
60
12
20
28
60
5
100
1.8
3
1.8
3
6
4.6
0.4
ns
ns
ns
MHz
ns
ps/oC
ns
% Clock
ns
ns
ns
V
V
Logic "1" Voltage
Filll
4.6
V
Logic "0" Voltage
Filll
0.4
V
POWER SUPPLy7
Positive Supply Current (+5.0 V)
Power Dissipation
Power Reduce Current
Power Reduce Dissipation
Power Supply Rejection Ratio
Propagation Delay Sensitivity (TEM)8
Filll
Filll
Filll
Filll
+25°C
140
170
mA
700
850
mW
70
85
mA
350
425
mW
1.5
nsN
NOTES
'Best Fit between codes 25 and 230. INL is very layout sensitive.
'Due to linearity mismatch in dual ramps.
'Measured from rising edge of clock to transition of Codes 0 to 255.
= 'Minimum pulse width (at 20 MHz) limited by rise time. Pulse width for Code 25 will be greater when CLOCK < 20 MHz.
'Oulput load 10 pF and 2 mA source/sink.
'Load conditions to test oulput drive capability. Linearity will degrade with either capacitive or current loading. Best linearity obtained driving a single CMOS input.
'All performance specifications valid when supply maintained at +5 V, :t5%.
"Tested from +4.75 V to +5.25 V.
Specification subject to change without notice.
-2-
REV. 0