OP07D Datasheet, PDF (13/16 Pages) Analog Devices – 150 μV Maximum Offset Voltage Op Amp

OUTLINE DIMENSIONS
5.00 (0.1968)
4.80 (0.1890)
8
4.00 (0.1574)
3.80 (0.1497) 1
5
6.20 (0.2440)
4 ^{5.80 (0.2284)}
0.25 (0.0098)
0.10 (0.0040)
COPLANARITY
0.10
1.27 (0.0500)
BSC
1.75 (0.0688)
1.35 (0.0532)
0.50
0.25
(0.0196)
(0.0099)
×
45°
0.51 (0.0201)
SEATING ^{0.31 (0.0122)}
PLANE
8°
0.25 (0.0098) ^{0° 1.27 (0.0500)}
0.17 (0.0067) ^{0.40 (0.0157)}
COMPLIANT TO JEDEC STANDARDS MS-012-AA
CONTROLLING DIMENSIONS ARE IN MILLIMETERS; INCH DIMENSIONS
(IN PARENTHESES) ARE ROUNDED-OFF MILLIMETER EQUIVALENTS FOR
REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN.
Figure 43. 8-Lead Standard Small Outline Package [SOIC_N]
Narrow Body
(R-8)
Dimensions shown in millimeters and (inches)
0.400 (10.16)
0.365 (9.27)
0.355 (9.02)
8
5
PIN 1
0.210
(5.33)
MAX
0.150 (3.81)
0.130 (3.30)
0.115 (2.92)
1
4
0.100 (2.54)
BSC
0.022 (0.56)
0.018 (0.46)
0.014 (0.36)
0.070 (1.78)
0.060 (1.52)
0.045 (1.14)
0.280 (7.11)
0.250 (6.35)
0.240 (6.10)
0.060 (1.52)
MAX
0.015
(0.38) _{0.015 (0.38)}
MIN
GAUGE
PLANE
SEATING
PLANE
0.005 (0.13)
MIN
0.325 (8.26)
0.310 (7.87)
0.300 (7.62)
0.195 (4.95)
0.130 (3.30)
0.115 (2.92)
0.430 (10.92)
MAX
0.014 (0.36)
0.010 (0.25)
0.008 (0.20)
COMPLIANT TO JEDEC STANDARDS MS-001-BA
CONTROLLING DIMENSIONS ARE IN INCHES; MILLIMETER DIMENSIONS
(IN PARENTHESES) ARE ROUNDED-OFF INCH EQUIVALENTS FOR
REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN.
CORNER LEADS MAY BE CONFIGURED AS WHOLE OR HALF LEADS.
Figure 44. 8-Lead Plastic Dual In-Line Package [PDIP]
(N-8)
Dimensions shown in inches and (millimeters)
OP07D
Rev. 0 | Page 13 of 16