ADUM2400 Datasheet, PDF (11/23 Pages) Analog Devices – Quad-Channel Digital Isolators, 5KV

Preliminary Technical Data
ADuM2400/ADuM2401/ADuM2402
NOTES
1 _{All voltages are relative to their respective ground.}
2 _{Supply current values are for all four channels combined running at identical data rates. Output supply current values are specified with no output load present. The}
supply current associated with an individual channel operating at a given data rate may be calculated as described in the Power Consumption section on page 20.
See Figure 8 through Figure 10 for information on per-channel supply current as a function of data rate for unloaded and loaded conditions. See Figure 11 through
Figure 14 for total IDD1 and IDD2 supply currents as a function of data rate for ADuM2400/ADuM2401/ADuM2402 channel configurations.
3 _{The minimum pulsewidth is the shortest pulsewidth at which the specified pulsewidth distortion is guaranteed.}
4 _{The maximum data rate is the fastest data rate at which the specified pulsewidth distortion is guaranteed.}
5 _{tPHL propagation delay is measured from the 50% level of the falling edge of the VIx signal to the 50% level of the falling edge of the VOx signal. tPLH propagation delay}
is measured from the 50% level of the rising edge of the VIx signal to the 50% level of the rising edge of the VOx signal.
6 _{tPSK is the magnitude of the worst-case difference in tPHL or tPLH that will be measured between units at the same operating temperature, supply voltages, and output}
load within the recommended operating conditions.
7 _{Co-directional channel-to-channel matching is the absolute value of the difference in propagation delays between any two channels with inputs on the same side of}
the isolation barrier. Opposing-directional channel-to-channel matching is the absolute value of the difference in propagation delays between any two channels
with inputs on opposing sides of the isolation barrier.
8 _{CMH is the maximum common-mode voltage slew rate that can be sustained while maintaining VO > 0.8VDD2. CML is the maximum common-mode voltage slew rate}
than can be sustained while maintaining VO < 0.8 V. The common-mode voltage slew rates apply to both rising and falling common-mode voltage edges. The
transient magnitude is the range over which the common mode is slewed.
9 _{Dynamic supply current is the incremental amount of supply current required for a 1 Mbps increase in signal data rate. See Figure 8 through Figure 10 for}
information on per-channel supply current for unloaded and loaded conditions. See Power Consumption section on page 19 for guidance on calculating per-
channel supply current for a given data rate.
Rev. PrD | Page 11 of 23