ADCMP551_0410 Datasheet, PDF (1/16 Pages) Analog Devices – Single-Supply, High Speed PECL/LVPECL Comparators

FEATURES
Single power supply
500 ps propagation delay input to output
125 ps overdrive dispersion
Differential PECL/LVPECL compatible outputs
Differential latch control
Internal latch pull-up resistors
Power supply rejection greater than 70 dB
700 ps minimum pulse width
Equivalent input rise time bandwidth > 750 MHz
Typical output rise/fall of 500 ps
Programmable hysteresis
APPLICATIONS
Automatic test equipment
High speed instrumentation
Scope and logic analyzer front ends
Window comparators
High speed line receivers
Threshold detection
Peak detection
High speed triggers
Patient diagnostics
Disk drive read channel detection
Hand-held test instruments
Zero-crossing detectors
Line receivers and signal restoration
Clock drivers
Single-Supply, High Speed
PECL/LVPECL Comparators
ADCMP551/ADCMP552/ADCMP553
FUNCTIONAL BLOCK DIAGRAM
HYS*
NONINVERTING
INPUT
INVERTING
INPUT
ADCMP551/
ADCMP552/
ADCMP553
Q OUTPUT
Q OUTPUT
LATCH ENABLE
INPUT
LATCH ENABLE
INPUT
*ADCMP552 ONLY
Figure 1.
GENERAL DESCRIPTION
The ADCMP551/ADCMP552/ADCMP553 are single-supply,
high speed comparators fabricated on Analog Devices’
proprietary XFCB process. The devices feature a 500 ps
propagation delay with less than 125 ps overdrive dispersion.
Overdrive dispersion, a measure of the difference in
propagation delay under differing overdrive conditions, is a
particularly important characteristic of high speed comparators.
A separate programmable hysteresis pin is available on the
ADCMP552.
A differential input stage permits consistent propagation delay
with a common-mode range from –0.2 V to VCCI – 2.0 V.
Outputs are complementary digital signals and are fully
compatible with PECL and 3.3V LVPECL logic families. The
outputs provide sufficient drive current to directly drive
transmission lines terminated in 50 Ω to VCCO − 2 V. A latch
input is included and permits tracking, track-and-hold, or
sample-and-hold modes of operation. The latch input pins
contain internal pull-ups that set the latch in tracking mode
when left open.
The ADCMP551/ADCMP552/ADCMP553 are specified over
the –40°C to +85°C industrial temperature range. The
ADCMP551 is available in a 16-lead QSOP package; the
ADCMP552 is available in a 20-lead QSOP package; and the
ADCMP553 is available in an 8-lead MSOP package.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
infringements of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: [phone]
www.analog.com
Fax: [phone] © 2004 Analog Devices, Inc. All rights reserved.