AD7879 Datasheet, PDF (1/36 Pages) Analog Devices – Low Voltage Controller for Touch Screens

Low Voltage Controller for Touch Screens
AD7879
FEATURES
4-wire touch screen interface
1.6 V to 3.6 V operation
Median and averaging filter to reduce noise
Automatic conversion sequencer and timer
User-programmable conversion parameters
Auxiliary analog input/battery monitor (0.5 V to 5 V)
1 optional GPIO
Interrupt outputs (INT, PENIRQ)
Touch-pressure measurement
Wake-up on touch function
Shutdown mode: 6 μA maximum
12-ball, 1.6 mm × 2 mm WLCSP
16-lead, 4 mm × 4 mm LFCSP
APPLICATIONS
Personal digital assistants
Smart hand-held devices
Touch screen monitors
Point-of-sale terminals
Medical devices
Cell phones
GENERAL DESCRIPTION
The AD7879 is a 12-bit successive approximation analog-to-
digital converter (ADC) with a synchronous serial interface and
low on-resistance switches for driving 4-wire resistive touch
screens. The AD7879 works with a very low power supply (a
single 1.6 V to 3.6 V) and features throughput rates of 105 kSPS.
The device includes a shutdown mode that reduces its current
consumption to less than 6 μA.
To reduce the effects of noise from LCDs and other sources,
the AD7879 contains a preprocessing block. The preprocessing
function consists of a median and an averaging filter. The com-
bination of these two techniques provides a more robust solution,
discarding the spurious noise in the signal and keeping only
the data of interest. The size of both filters is programmable.
Other user-programmable conversion controls include variable
acquisition time and first conversion delay; up to 16 averages
can be taken per conversion. The AD7879 can run in either
slave or standalone mode, using an automatic conversion
sequencer and timer.
FUNCTIONAL BLOCK DIAGRAM
V_CC/REF
X+
X–
Y+
Y–
GND
REF–
TEMPERATURE
SENSOR
X– Y– X+ Y+
REF– REF+
12-BIT
SAR ADC
AD7879/
AD7879-1
RESULT
REGISTERS
CONTROL
REGISTERS
TO
RESULT
REGISTERS
SERIAL PORT
CS/ DIN/ DOUT/ SCL
ADD0 ADD1 SDA
Figure 1.
SEQUENCER
AND TIMER
The AD7879 has a programmable pin that can operate as an
auxiliary input to the ADC, as a battery monitor, or as a GPIO.
There is also a programmable interrupt output that can operate
in three modes: as a general-purpose interrupt to signal when
new data is available INT, as an interrupt to indicate when limits
are exceeded, or as a pen-down interrupt when the screen is
touched (PENIRQ). The AD7879 offers temperature measure-
ment and touch-pressure measurement.
The AD7879 is available in a 12-ball, 1.6 mm × 2 mm WLCSP
and in a 16-lead, 4 mm × 4 mm LFCSP. The part also has either
an SPI (AD7879) or I²C (AD7879-1) interface.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: [phone]
www.analog.com
Fax: [phone]
©2008 Analog Devices, Inc. All rights reserved.