ACTF4001_10 Datasheet, PDF (3/3 Pages) Advanced Crystal Technology – SAW Filter

Tel : [phone]
Fax : [phone]
Email: [e-mail]
5-2.Electronic Characteristics
Characteristics
Minimum Typical Maximum Units
Centre Frequency
Usable Pass Band
fC
--
426.000
--
MHz
BW
--
±2.0
MHz
Insertion Loss (fC±2.0MHz)
IL
Rejection
fC <fC – 20.0MHz
fC >fC +25.0MHz
3.5
5.0
dB
40
45
45
50
--
dB
Pass Band Ripple (with fC±2.0MHz)
Input and Output Impedance
--
2.0
--
dB
50 Ω
iCAUTION: Electrostatic Sensitive Device. Observe precautions for handling!
1. Unless noted otherwise, all measurements are made with the filter installed in the specified test fixture that is
connected to a 50Ω test system with VSWR≤1.2:1. The test fixture L and C are adjusted for minimum insertion
loss at the filter centre frequency, f C. Note that insertion loss, bandwidth, and passband shape are dependent on
the impedance matching component values and quality.
2. Unless noted otherwise, specifications apply over the entire specified operating temperature range.
3. The specifications of this device are based on the test circuit shown above and subject to change or
obsolescence without notice.
4. All equipment designs utilizing this product must be approved by the appropriate government agency prior to
manufacture or sale.
5. Our liability is only assumed for the Surface Acoustic Wave (SAW) component(s) per se, not for applications,
processes and circuits implemented within components or assemblies.
In keeping with our ongoing policy of product evolvement and improvement, the above specification is subject to change without notice.
ISO9001: 2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berks, RG41 2EY, UK
http://www.actcrystals.com
Issue : 1.1 C1
Date : March 2010