English
Language : 

ACTMPX11-6 Datasheet, PDF (1/3 Pages) Advanced Crystal Technology – LVPECL Saw Oscillator
Tel :
Fax :
email :
0044 (0)118 979 1238
0044 (0)118 979 1283
info@actcrystals.com
ACTMPX11-6 LVPECL Saw Oscillator
The ACT MPX11-6 is a PCB Based, SMD, LVPECL Saw oscillator. This 14 x10.3mm device can be
used in a wide range of applications, especially where a high fundamental frequency with low phase
noise and jitter are required. This device is offered in a range of standard, frequencies from
311.04~625.0 MHz, common to communications applications.( SONET / SDH etc.. ) The devices ar
available reeled ( 500 pcs ) or loose to suit high/low volume requirements.
Specification
Parameter
Supply Voltage
Frequency Range
Frequency Stability
Temp Operating Range
Temp Storage Range
Supply Current (max)
Duty Cycle
Output Level ‘0’
Output Level ‘1’
Rise & Fall Time (max)
Output Load
Jitter
Aging
Symbol
VDD
fo
Δf/fo
Topr
Tstg
Iop
Tw/t
VOL
VOH
TrTf
N/CL
Fa
Phase Noise
Specification
3.3VDC ± 10%
311.040 MHz, 312.500 MHz,400.00MHz, 622.080MHz, 625.00MHz
±25ppm ~ ±50ppm
0 ~ +70°C Std ( -40 ~ +85°C available)
-55 to +125°C
130mA max
45/55%
VDD-1.620Vdcmax
VDD -1.025Vdc min
800pS max
VDD-2.0Vdc to 50 ohm
1.0pS max
±3ppm / year
-65dBc/Hz
-98dBc/Hz
-125dBc/Hz
-130dBc/Hz
-135dBc/Hz
Condition
Please specify
Please specify
Please specify
12kHz to 20MHz
@25°C
@10Hz
@100Hz
@1kHz
@10kHz
@100kHz
Dimensions (mm)
Pin Connection
#1 Tri-state
#2 N/C
#3 Ground
#4 Output
#5 Complementary Output
#6 Vdd
Pad surface material Au
Please note that all parameters can not necessarily be specified in the same device
Customer to specify : Frequency, Frequency Stability, Operating Temperature Range,
In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice
ISO9001:2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK
http://www.actcrystals.com
1 of 3