ABLNO-EVAL Datasheet, PDF (1/7 Pages) Abracon Corporation – Frequency Divider Evaluation Board

Frequency Divider Evaluation Board
ABLNO- EVAL
Pb ^{RoHS Compliant}
60.4 x 42.7 x 13.0 mm
|||| ||||||| ||||
OVERALL CAPABILITY
ABLNO-EVAL; Frequency Divider Evaluation Board shown in figure (1) is designed to facilitate engineering evalu-
ation of Abracon’s Ultra Low Noise – ABLNO series of fixed clock and voltage controlled crystal oscillators.
Further, there is a provision through the RF_IN SMA Connector to supply any other oscillator signal between 10MHz
and 200MHz; if ABLNO series is not being characterized.
This Evaluation Board is ideal to conduct the following measurements:
• Phase Noise and rms jitter for ÷1, ÷2, ÷4 and ÷8 frequency outputs
• Frequency Pull Characteristics of the ABLNO by using the Vc port as the control voltage
• Frequency Stability over operating temperature (-40ºC to +85ºC)
Figure (1)
Designers who are interested in using the ABLNO as an Ultra Low Noise platform device to generate additional
Low Noise frequencies will find this Evaluation Board to be of exceptional value. Abracon has implemented Ultra
Low Noise ÷2, ÷4 and ÷8 circuitry on this board, that can also be incorportated in end-customer solutions; please
contact [e-mail] for additional details.
Tpycial Phase Noise and jitter peformance in ÷1, ÷2, ÷4 and ÷8 modes is depicted in section 2.0.
ABRACON IS
ISO9001:2008
CERRTTIIFFIIEEDD
Visit www.abracon.com for Terms & Conditions of Sale Revised: 06.06.13
30332 Esperanza, Rancho Santa Margarita, California 92688
tel [phone] | fax [phone] | www.abracon.com