AAT2806 Datasheet, PDF (10/16 Pages) Advanced Analogic Technologies – Dual High Efficiency Charge Pump for White LED AND Flash Applications

AAT2806
Dual High Efficiency Charge Pump
for White LED and Flash Applications
Functional Block Diagram
EN_FLSH
V_IN
Soft-Start
1MHz
Oscillator
C3⁺ C3^-
2X Charge
Pump
EN/SET
Control
Logic
Soft-Start
Control
1MHz
Oscillator
Voltage
Reference
1X
1.5X
2X
Charge
Pump
6 x 16 Bit
ROM
6 x 16 Bit
ROM
V_REF
D/A
D/A
D/A
D/A
V_{OUT_FLSH}
C1+
C1-
C2+
C2-
V_{OUT_BL}
D1
D2
D3
D4
GND
Functional Description
The AAT2806 is a dual charge pump designed for
flash and white LED applications. The backlight
charge pump is a tri-mode load switch (1X) and high
efficiency (1.5X or 2X) charge pump device. To max-
imize power conversion efficiency, an internal sens-
ing circuit monitors the voltage required on each con-
stant current sink input and sets the load switch and
charge pump modes based on the input battery volt-
age and the current sink input voltage. As the battery
voltage discharges over time, the white LED charge
pump is enabled when any of the four current sink
inputs near dropout. The charge pump initially starts
in 1.5X mode. If the charge pump output drops
enough for any current source output to become
close to dropout, the charge pump will automatically
transition to 2X mode. The four constant current sink
inputs D1 to D4 can drive four individual LEDs with a
maximum current of 20mA per LED. The unused sink
inputs must be connected to V_{OUT_BL}; otherwise, the
part will operate only in 2X charge pump mode. The
S²Cwire serial interface enables and sets the con-
stant current sink magnitudes. S²Cwire addressing
allows the LED main channels D1 to D3 to be con-
trolled independently from the LED sub-channel D4.
10
2806.2006.04.1.8