1557932 Datasheet, PDF (4/13 Pages) 3M Electronics – 3M Scotch-Weld AC68 Cyanoacrylate Debonder

3M Scotch-Weld AC68 Cyanoacrylate Debonder
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient
CAS Nbr Agency
Acetone
67-64-1 Health and
Safety Comm.
(UK)
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
Limit type
Additional comments
TWA:1210 mg/m³(500
ppm);STEL:3620 mg/m³(1500
ppm)
8.2. Exposure controls
8.2.1. Engineering controls
Provide appropriate local exhaust ventilation at transfer points. Use general dilution ventilation and/or local exhaust
ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray.
If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Wear eye/face protection.
The following eye protection(s) are recommended: Safety glasses with side shields.
Indirect vented goggles.
Skin/hand protection
Wear protective gloves.
Gloves made from the following material(s) are recommended: Fluoroelastomer
Polyethylene.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half face piece or full face air-purifying respirator with organic vapour cartridges.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state
Liquid.
Appearance/Odour
pH
Boiling point/boiling range
Melting point
Flammability (solid, gas)
Explosive properties
Clear; Slight odour.
Not applicable.
235 ºC
Not applicable.
Flammable Liquid: Category 4.
Not classified
__________________________________________________________________________________________
Page: 4 of 13