10214-1S10PL Datasheet, PDF (1/6 Pages) 3M Electronics – 3M Mini D Ribbon (MDR) Connectors

3M^™ Mini D Ribbon (MDR) Connectors
.050” Surface Mount Right Angle Die-Cast Receptacle – Shielded
102 Series
• Rugged die-cast body resists tipping during automated
soldering operations
• Wiper-on-wiper contact for reliable repetitive plugging
• Ultra-low signal skew for high data rate transmission
• Interface latch design for connection stability
• Suitable for thumbscrew attach (see TS-0142 for
available hardware)
• MDR digital LCD interface as a 20 or 26 contact
connector
• Camera Link^® interface as a 26 contact connector
• Contacts: 14, 20, 26, 40 and 50
• See Regulatory Information Appendix (RIA) for
chemical compliance information
Date Modified: December 20, 2007
Physical
Body Material: Glass Reinforced Polyester (PCT), Natural Color
Flammability: UL 94V-0
Alignment Plate Material: LCP, Natural Color
Flammability: UL 94V-0
Contact Material: Copper Alloy
Underplating: 80 µ” [2 µm] Nickel
Wiping Area Plating: See Ordering Information
Solder Tail Plating: Flash Gold over Nickel (RIA E1 & C1 apply)
Shroud Material: Steel
Plating: Nickel
Lock Stand Material: Zinc Alloy
Plating: Nickel
TS‑2242-A
Sheet 1 of 3
Electrical
Current Rating: 1 A
Insulation Resistance: >5 x 10⁸ Ω at 500 V_DC
Withstanding Voltage: 500 V_RMS for 1 minute

Environmental
Temperature Rating: -55 °C to +85 °C
Process Rating: 240°C- 250°C peak temperature for less than 10 secs., 220°C soldering for 30 – 60 secs. after
150°C - 180°C preheat for 90 –120 secs. (reflow two times)
UL File No.: E68080
3
Interconnect Solutions
http://www.3M.com/interconnects/
Camera Link^® is a trademark of Automated Imaging Assocition
3M is a trademark of the 3M Company
For technical, sales or ordering information call
800-225-5373